Repiping and pipe replacement in Orlando, FL
From a single failing section to a whole home repipe. We show you what is failing and why, and quote the partial and the full job where both are real options.
- Upfront, quoted pricing
- Drywall finished by us
- Licensed plumbers
SCHEDULE SERVICE TODAY
Tell us what you need and we will reach out fast.
Signs your Orlando home needs repiping
One of these on its own is a repair. Several together is a pattern.
Multiple leaks
More than one leak in the past year in different parts of the house
Less water pressure
Water pressure dropping gradually across the whole house
Discolored water
Rusty or discolored water, especially first thing in the morning, which can also point at the tank rather than the pipe and is covered on our Orlando water heater repair page
Staining
Visible corrosion or green staining on exposed pipe
Polybutylene pipes
Usually gray or blue plastic, common in Orlando homes built through the eighties
Galvanized steel supply lines
Which corrode closed from the inside
Pinhole leaks
Pinhole leaks in copper, which rarely happen just once
How much does repiping cost in Orlando?
A whole home repipe in Orlando generally runs between $4,000 and $10,000. PEX sits at the lower end of that and copper at the upper, and the biggest variables are the number of bathrooms, whether the house is single or two story, and how accessible the runs are. A slab home with limited attic access costs more than one where the plumbing can be reached from above.
A single section repair, where only one run has failed, is a much smaller job at $150 to $500. Replacing the water line from the meter to the house typically falls between $255 and $760.
Orange County permit fees for a repipe run $185 to $385 depending on fixture count. The permit, the inspection, and closing and finishing the drywall are all part of what we quote rather than extras that appear later.
When repiping an Orlando home costs less than patching
A repipe is a large job and nobody wants one. The reason it eventually wins is arithmetic. Once a system starts failing in more than one place, each repair buys a shorter interval than the last, and you end up paying for the repipe in installments while living with the disruption repeatedly.
The tell is a pattern rather than an event. Two leaks in a year in different parts of the house means the material is at the end of its life, not that you were unlucky twice. Where only one run has failed, leak detection in Orlando finds it and a section repair is usually enough.
In Orlando that usually means one of three things: polybutylene, installed widely here through the eighties and known to fail without warning; older galvanized steel, which corrodes from the inside and strangles your pressure; or copper thinned by hard water and starting to pinhole.
Section repair or whole home repipe in Orlando?
A repipe is a big job and not always the right one. Here is how to tell which situation you are in.
A section repair is enough when
- One failure in one place with no pattern
- The rest of the system is a material with life left in it
- Pressure normal everywhere else
- Water clear at every tap
A repipe is the better value when
- Repeat failures in different areas
- Polybutylene or galvanized throughout
- Pressure down across the whole house
- Discolored water at multiple fixtures
- You are already opening walls for another project
Get an Orlando repipe quote
We map the system, identify the material, and quote the whole job before starting rather than running an hourly meter.
What an Orlando repipe involves
Two to four days for most Orlando homes, and in nearly every case you have water at the end of each working day.
Assessment and upfront quote
We map the system, identify the material, and quote the whole job before starting rather than running an hourly meter.
Protection and access
urnishings covered and access points cut deliberately rather than exploratorily.
New lines run
PEX or copper depending on the home and your preference, with the tradeoffs explained rather than decided for you.
Pressure test and inspection
Tested and permitted before anything closes up.
Patch and finish
Drywall closed and finished, and the site left clean.
Areas we provide repiping services in Orlando
We repipe homes across Orlando and southern Orange County. Not sure if we service your area? Call us today to check at (863) 345-0493
- Hunters Creek
- Lake Nona
- Dr. Phillips
- Bay Hill
- Winderemere
- Meadow Woods
- Southchase
- Oak Ridge
- Azalea Park
- Pine Hills
- Maitland
What Orlando homeowners say about our repipe work
Reviews from our loyal and valued customers across Orlando and Orange County.
Book an Orlando repipe assessment
The permit, the inspection, and closing and finishing the drywall are part of what we quote rather than extras that appear later.
Orlando Repiping FAQ
Common questions our plumbers get in Orlando about piping services
How long does a whole home repipe take in Orlando?
Most Orlando homes take two to four days depending on size and access. We give you the timeline with the quote, and in nearly every case you have water at the end of each working day.
Do I have polybutylene pipe?
It is gray or blue flexible plastic pipe, usually with metal or plastic crimp fittings, installed widely in Central Florida through the eighties. If your home is from that era it is worth having checked, because it fails without warning and insurers increasingly ask about it.
PEX or copper for an Orlando repipe?
Both are good. PEX is faster to install, more forgiving of a slab layout, and costs less. Copper lasts longer where water chemistry is kind, though hard water works against it here. We explain the tradeoffs for your house rather than defaulting to one.
Will you patch the drywall after repiping?
Yes. Closing and finishing the access points is part of the job we quote, not a separate trade you have to arrange afterward.